30
© 2008 Directed Electronics- All rights reserved.
➢ Disarming the VRS
Take the time to familiarize yourself with the VRS
®
trig ger ing se-
quence and the disarm pro ce dure. It is important to recognize
and identify the VRS trigger sequence and know how to disarm it
in case of ac ci den tal activation.
Once the VRS is armed, it does not disarm au to mat i cal ly. You must
disarm it the next time you operate the vehicle. You must dis arm it
with one of the fol low ing pro ce dures:
If the system has not entered the triggered sequence (siren has not
started chirping):
1. Turn the ignition on.
2. Press
on the transmitter for one second. The
lights will flash and the siren will chirp twice.
If the system has entered the triggered sequence
(siren has begun chirping), pressing the disarm but-
ton of the trans mit ter will not disarm VRS. To disarm
the VRS during a VRS trigger sequence:
1. Turn the ignition on.
2. Press the Valet switch
the pre-programmed num-
ber of times to disarm the
VRS system.
Note: If the VRS system has begun its chirping sequence, the
ignition must be turned off, then on to disarm. If you are driving
the vehicle at the time, pull to a safe place away from traffic and
follow the triggered sequence disarm procedure.
Online-store car audio and autogoods Winauto
winauto.ua
To Next Page
Loading...
Need help?
General
