DirecTV H20 - Network Setup; Remote Control

Chapter 4 - Settings
65
Chapter
1
Chapter
2
Chapter
3
Chapter
4
Chapter
5
Chapter
6
Network Setup
Select “Network Setup” to configure and test the connection of your
receiver to the Internet. See Appendix 2 for details.
High-DefinitionReceivers
When the MODE switch on your remote is in the left-most position, it
controls your DIRECTV receiver. However, you can also program the
AV1, AV2 and TV positions to control other equipment such as your TV,
DVD, VCR or Stereo. From System Setup, select “Remote Control” (SD :
“Remote”) and then “Program Remote.” It is helpful to know the model
number as well as the brand of the equipment to produce the best results
when programming the remote. To clear current AV1, AV2 and TV settings
use the “Reset Remote” option.
Remote Control
Note:This option is not available on model H20.
System Setup