66
DIRECTV
®
NON-DVR USER GUIDE
This option is typically only used by installers when your system is initially
set up. However, you can come here to see the satellite signal strength your
receiver is getting or to repeat the satellite setup procedure.
Satellite
Certain remote control models feature RF (radio frequency) capability.
Refer to the model number printed on the top left corner of your
DIRECTV Remote Control. Look for the letter(s) “R” or “RB” at the
end of the model number which indicates that the remote supports
radio frequency. To change your remote method of transmission from
Infrared (IR) signals to RF, select “Remote Control” and then “IR/RF
Setup”. While IR transmission requires a clear line of sight to the front
of the receiver, RF transmission lets your put your receiver inside a
cabinet or behind solid doors and still be able to command it from up to
200 feet away.
High-DefinitionReceivers
IR/RF Setup
System Setup
To Next Page
Loading...
