67
DIRECTV
®
WHOLE-HOME DVR SERVICE
CHAPTER 5 - EXTRAS & SPECIAL FEATURES
2. Activate DIRECTV
®
Whole-Home DVR Service:
Once DIRECTV
®
Whole-Home DVR service is activated on your
account, press the LIST button on your remote. The message
on the right will display, confirming the service has been
enabled. Select “Continue”.
3. Name Your Locations:
You’ll be prompted to give each receiver a name. We refer to
this as “Location”. We recommend using a name that you’ll
easily associate with the room or it’s location, such as, “Living
Room”. The name must be 14 characters or less. You must
be at the receiver to assign its name.
After you’ve assigned a Location Name, you can change it
as follows: Press MENU, select “Settings & Help”, then
“Settings”, “Whole-Home” and then “Name Location”.
4. Set Playlist Sharing Options (HD DVR only):
During initial setup, if the receiver is an HD DVR, you’ll be
prompted to set the following Playlist sharing options:
To Next Page
Loading...
