DirecTV Wireless Cinema Connection Kit - Direct Ethernet Connection Setup

To Next Page

To Previous Page

DIRECTV Field Operations Training

©DIRECTV 2011

DIRECTV W-DCCK

Version 1.3.0

Notes DIRECTV Wireless Cinema Connection Kit

Installing a Wireless Cinema Connection Kit

Direct Ethernet Connection

1. Using the supplied Ethernet cable, connect one end of the Eth-

ernet cable to the Ethernet port of the W-DCCK device.

2. Connect the other end of the Ethernet cable to the Ethernet

port on the back of the DIRECTV Receiver. If the DIRECTV Re-

ceiver has two Ethernet ports, connect the cable to the upper

port labeled “ETHERNET 1”.

3. The POWER and Activity LEDs on the W-DCCK light up. Wait for

the POWER LED to stop ashing.

• If the LEDs do not light up, go the Troubleshooting section.

4. Perform one of the following steps:

• WPS Connection to Router Established: go to the section

below, Complete Wireless Protected Setup.

• WPS Connection to Router Not Supported or Established:

go to the section below, Manual Wireless Setup.

Note: For each receiver that requires an internet connection, a W-

DCCK is required.