10
EN
To activate this function, keep the On/off key
pressed down until the display shows
F6
, and then release the key to directly enable ºF. To return to ºC, keep the control panel
key
pressed down with the unit switched off, at which point C will flash on the
display
c
C
when it stops flashing, release the control panel key . The control
is disabled when carrying out this operation, meaning it must be registered again once
nished.
Function
F1
-
Digital thermometer function
Function
F6
-
Selecting ºF
In this function, Integral Power displays the interior cabin temperature.
By selecting
F0
the display shows the selected temperature and allows the user to choose
the comfort temperature that will appear on the display from 15ºC to 27ºC or 59ºF to 71ºF and
vary the speed of the centrifugal blower equipment (5 speeds indicated by
V1
to
V5
).
The comfort temperature is controlled by briey pressing the
keys on the control
panel or
on the remote.
Centrifugal blower speeds are controlled by holding down the
keys on the control
panel or from the command
on the remote control, the display will show
V1
,
V2
,
V3
,
V4
,
V5
. When the machine is running the selected degrees will appear on the display.
Function
F0
-
Manual Operation
By selecting
F4
the user can select the comfort temperature 15ºC to 27ºC or 59ºF to 71ºF
to be selected from the
keys on the control panel or the remote control buttons
. When selected
CA
will appear interspersed on the display and the temperature
selected. With this function the equipment automatically regulates and monitors the comfort
temperature by acting on the speed of the centrifugal blower and the compressors. By
pressing the
key on the remote control the
F4
function is cancelled and moves to
F0
(Manual Function). On starting the machine for the rst time it starts on
F4
with the factory
settings.
Function
F4
-
Automatic operation of the equipment
To Next Page
Loading...
