dirna Bergstrom INTEGRAL POWER - Integral Power Remote Control Operation; Remote Control Key Functions; Registering the Remote Control

INTEGRAL POWER
Air conditioning for vehicles
11
EN
Remote control functions:
Unit on/off.
Note: This key is used to run the unit in automatic
mode F4
Centrifugal blower speed control (Manual mode only):
Note: with the unit running in automatic mode F4 , the unit will
pass into manual mode F0 . when this key is pressed. Users
can therefore use this key to choose the required airow, with
the display showing U1 , U2 , U3 , U4 , U5 , U4 , U3 , U2 , U1 .
Temperature control: Comfort temperature can be controlled
by briey pressing the keys (15/27ºC - 59/80ºF).
Remote control
Registering the remote control:
To register the remote control, keep the key of the control panel pressed down
with the unit off. The display will flash C
C
.When it stops ashing, press the On/Off
key on the remote control within 30 seconds and the unit will give out an acoustic
signal as conrmation. If this does not happen, repeat the whole operation.
1
1
2
2
3
3