15
SETTING UP A TV1 UHF PRO REMOTE FOR THE
DISH PLAYER-DVR 522 AND 625 ONLY
Use these special instructions only if you are going to use the green 1
UHF Pro key to control the TV1 side of a DISH Player-DVR 522 or
DISH Player-DVR 625.
When you are finished setting up the remote control, you’ll be able to
operate the TV1 side of your DISH Player-DVR 522 or 625 from long
distances.
1 Make sure the key is installed as described on pages
C-1 and C-2.
2 Make sure the UHF Antenna is attached to the
R
EMOTE ANTENNA input on the back of the receiver.
3 Using the receiver’s front panel buttons, press MENU. Select the
following on-screen items in this sequence:
a. System Setup.
b. Installation.
c. TV1 UHF Pro Setup.
4 Select Enable from the TV1 UHF Pro Setup screen.
5 Select System Info to open the System Information screen.
HOLD FOR
RESET
To Next Page
Loading...
