EasyManua.ls Logo

Dish Network D1000.4 EA User Manual

Dish Network D1000.4 EA
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
D1000.4 EA
and
D1000.4 WA
182947
Installation Instructions
To subscribe to programming, or for assistance with
installing or using the system, call Customer Service at
1- 80 0- 89 4- 91 31
Question and Answer IconNeed help?

Do you have a question about the Dish Network D1000.4 EA and is the answer not in the manual?

Dish Network D1000.4 EA Specifications

General IconGeneral
TypeSatellite Dish Antenna
ModelD1000.4 EA
CompatibilityDish Network
Satellites Covered61.5°W, 72.7°W, 77°W
LNB TypeTriple LNB
Mounting TypeMast Mount
UsageResidential
Frequency Range12.2 - 12.7 GHz
PolarizationCircular

Summary

Important Safety Instructions

Important Safety Instructions

Provides essential safety guidelines for installing and using the satellite reflector system.

Installation Instructions

Overview

Introduces the DISH Network DISH 1000.4 satellite reflector and its components.

Installation Considerations

Details important factors and requirements for a successful satellite reflector installation.

About the System

Explains the DISH Pro Plus 1000.4 LNBFs and their connection capabilities for receivers.

Locating the Satellite Reflector

Assembling and Mounting the Satellite Reflector

Provides instructions for assembling the satellite reflector and mounting it to the mast.

Completing Installation

Connect peaking meter to LNBF

Connect a temporary cable to a peaking meter for signal testing.

Mount LNBF onto LNBF arm

Mount the LNBF assembly onto the adapter bracket and LNBF arm.

Mast Bolts and Torque Values

Torque Values

Details torque specifications for various bolts used in the satellite reflector installation.

Fine-tuning Azimuth and Elevation

Fine-tune the azimuth angle

Adjust the satellite reflector's azimuth angle for maximum signal strength.

Fine-tune elevation angle

Adjust the satellite reflector's elevation angle for maximum signal strength.

Eastern Arc LNBF to DPP44 Switch Connection

Connecting the DPP 1000.4 Eastern Arc LNBF

Explains how to connect the Eastern Arc LNBF to a DISH Pro Plus 44 switch.

Western Arc LNBF to DPP44 Switch Connection

Connecting the DPP 1000.4 Western Arc LNBF

Explains how to connect the Western Arc LNBF to a DISH Pro Plus 44 switch.

Receiver Connection and Testing

Connect switch and receiver

Connects the switch to the receiver and displays the Point Dish screen.

Run Check Switch test

Performs a Check Switch test to verify satellite reception on all tuners.

Finalizing Installation Steps

Verify signal strength bar

Confirms signal strength bars are green and locked on the Point Dish screen.

Take a software download

Initiates a receiver software download for optimal performance.

Run Check Switch again

Re-runs the Check Switch test to confirm satellite reception.

Install additional receivers

Guides on installing additional receivers after the initial setup.

Connecting a Second Satellite Reflector

Install and peak the second satellite reflector

Installs and peaks a second satellite reflector for additional satellite locations.

Connect coaxial cable to LNB IN port

Connects the second reflector's LNBF to the DPP 1000.4 LNBF's LNB IN port.

Run Check Switch on all receivers

Runs Check Switch on all connected receivers to verify reception from the second reflector.

Related product manuals