Dish Network Hopper Setup Guide

3.
Connecting the Cables to Your Replacement Receiver
a.
Connect the Satellite In cables to
the "Satellite In" ports and connect
the Home Distribution cables to the
"Home Distribution" port on the
replacement receiver.
Your Satellite In and Home Distribution
connection will look like one of the
following images.
b.
Connect either the HDMI cable,
YPbPR cables, or RCA cables from
the TV to the corresponding port(s)
on the replacement receiver.
c.
Connect the Ethernet cable to the
"Ethernet" port on the replacement
receiver.
You may not have this cable.
YPbPr
COMPONENT
YPbPr
COMPONENT
RCA
COMPOSITE
RCA
COMPOSITE
SATELLITE INSATELLITE IN
P
P
PLUS
INPUT
TRIPLEXER
175284
DC & DiSEqC PASS
950-1450 MHz1650-2150 MHzUHF/VHF
54-2150 MHz
SATELLITE INSATELLITE IN
P
P
PLUS
INPUT
SEPARATOR
123254
DC & DiSEqC PASS
HOME
DISTRIBUTION
HOME
DISTRIBUTION
or
TV2TV2

Dish Network Hopper Specifications

General

Storage Capacity	2TB
Tuners	16
4K Support	Yes
Whole-Home DVR	Yes
Commercial Skip	Yes (AutoHop)
Video Output	HDMI
Audio Output	HDMI, Optical
Connectivity	Ethernet, Wi-Fi
Output Resolution	1080p, 720p
Supported Apps	Netflix, YouTube, Pandora