Distech Controls Allure EC-Smart-Vue Series User Manual

Allure™ EC‑Smart‑Vue Sensor Series
Figure1: (Left image) Allure EC Smart Vue, Allure EC Smart Vue-H/-C/-CH sensors. (Right image) Models equipped with a motion
sensing window in the upper left corner: Allure EC Smart Vue-M/-CM/-HM/-CHM sensors
Product Description
The Allure EC-Smart-Vue Series is designed to interface with Distech Controls’ ECLYPSE™ series BACnet/IP and Wi-Fi Controllers, ECB series BAC-
net
®
Controllers and ECL series LONWORKS
®
Controllers.
This line of communicating sensors with backlit display consists of eight models that provide precise environmental zone control. Models are available
with any combination of the following: temperature, humidity, CO
2
, and motion sensor.
General Installation Requirements
For proper installation and subsequent operation of the device, pay special attention to the following recommendations:
£ Upon unpacking, inspect the contents of the carton for shipping damages.
Do not install a damaged device.
£ Allow for proper clearance around the device’s enclosure and wiring terminals to provide easy access for hardware configuration and maintenance.
£ Orient the device with the ventilation slots towards the top to permit proper heat dissipation.
£ Ensure proper ventilation of the device and avoid areas where corroding, deteriorating or explosive vapors, fumes or gases may be present.
Any type of modification to any Distech Controls product will void the product’s warranty
Take reasonable precautions to prevent electrostatic discharge to the device when installing, servicing or during operation. Discharge
accumulated static electricity by touching one’s hand to a well-grounded object before working with the device.
General Wiring Recommendations
Risk of Electric Shock:
Turn off power before any kind of servicing to avoid electric shock.
£ All wiring must comply with electrical wiring diagrams as well as national and local electrical codes.
£ Comply with all network and power supply guidelines outlined in the Network Guide.
£ Use the screws, wall anchors, and wire nuts included for wall mounting and wiring.
I n s t a l l a t i o n G u i d e

Distech Controls Allure EC-Smart-Vue Series Specifications

General

Brand	Distech Controls
Model	Allure EC-Smart-Vue Series
Category	Accessories
Language	English

Summary

Product Description and General Requirements

General Installation Requirements

Key recommendations for safe and proper installation of the sensor device.

General Wiring Recommendations

Guidelines for connecting the sensor, including safety and compliance.

Mounting and Physical Setup

Wall Mounting Procedure

Detailed steps for mounting the sensor onto a wall or junction box.

Connector and Jumper Configuration

Identifies and explains the function of various connectors and jumpers on the sensor.

Controller Compatibility and Network Bus

Supported Sensor Quantity

Information on the number of Allure EC-Smart-Vue sensors a controller can support.

Subnetwork Bus Specifications

Details on the subnetwork bus, including total length and typical topology.

EOL Terminations Configuration

How to configure End-of-Line terminations for devices on the subnetwork bus.

Commissioning Procedures

Setting Sensor Subnet ID

Procedure to set or verify the unique Subnet ID for each Allure EC-Smart-Vue sensor.

Controller Settings

Setting the BAUD Rate

Optional procedure for setting the BAUD rate for ECB series controllers.

Sensor Network and Feature Configuration

Setting the LAN Type

How to configure the sensor for BACnet or LONWORKS network communication.

Motion Sensor Setup and Testing

Guide to setting up, testing, and adjusting the motion sensor functionality.

Network Access Methods

BACnet Network Access

Instructions for accessing the BACnet network from the sensor for maintenance.

LONWORKS Network Access

How to enable and configure the sensor for LONWORKS network access.

Troubleshooting and Error Codes

Error Code Interpretation

Explains the meaning of error codes displayed on the sensor.