Distech Controls, Inc. – 4205 place de Java, Brossard, Quebec, J4Y 0CA, Canada / Tel: +1 450 444 9898 / Fax: +1 450 444 0770
Quick Start Guide
ECLYPSE Connected Thermostat (ECY-STAT)
Locating the Default Network Congurations on the ECY-STAT (Home > About)
Default User Credentials
Use the following credentials to access the ECLYPSE Web Interface:
Username: admin
Password: admin
This password is only valid for a rst-time connection and you will be prompted to change it after your rst
login. Please ensure note down the changed password.
Default IP Congurations
The default WiFi IP address for the ECY-STAT Hotspot is 192.168.0.1.
The ECY-STAT is also automatically set in DHCP mode and requires a connection to a router acting as DHCP
server to communicate to a network. This setting may be changed through the ECLYPSE Web Interface.
Resetting WiFi Congurations
The Reset Wi-Fi Conguration option will re-activate the Hotspot on the ECY-STAT. It is used when an
ECY-STAT in Wi-Fi client mode is unable to connect to its Wi-Fi network, because of a wrong password, for
instance. To perform this, select Main Menu > Settings > Advanced Settings (you may have to enter your login
credentials again) > Reset Wi-Fi Conguration.
Follow these simple steps to get started with the ECLYPSE Connected Thermostat:
There are two networking methods to connect to an ECY-STAT for the rst time:
• Wi-Fi.
• Wired (Ethernet connection to a router that will act as a DHCP server).
Once you have connected the thermostat(s) to a network, congure the thermostat.
Connection Procedures
General Information
To Next Page
Need help?
General
