To Next Page
Z
zperryAug 18, 2025
Why is my Distech Controls ECL/ECB-103 Controller not turning on even though it's powered?
- KKerry NunezAug 18, 2025
If your Distech Controls Controller is receiving power but not turning on, there could be a few reasons. Here's what to check: * **Blown Fuse:** If it's a 24V controller, the fuse may have blown. Disconnect the power, check the fuse, and reconnect the power. * **Power Supply Polarity:** Make sure that consistent polarity is maintained between all controllers and the transformer. Ensure the COM terminal of each controller is connected to the same terminal on the secondary side of the transformer. * **Insufficient Power:** If it's a 24V controller, the transformer may not be powerful enough. Verify that the transformer used is powerful enough to supply all controllers.
General
