Controls - 32 420sx Operator’s Manual
Tractor
CMW
4. Cruise control To set cruise speed:
• Adjust both controls fully
counter clockwise.
• Move joystick fully in
direction of travel.
• Slowly adjust controls
clockwise until you reach
desired speed.
• Return joystick to neutral
to stop travel.
To resume cruise speed,
move joystick in desired
direction of travel.
IMPORTANT:
• The control toward the front is
forward.
• The control toward the rear is
reverse.
• When plowing or trenching, allow
unit to operate as fast as possible
without overloading engine.
• When drilling, use control to
adjust speed (instead of joystick)
to reduce the risk of bending drill
rod.
5. Seat belt To fasten, insert latch into
buckle. Adjust until seat belt
is low and tight.
NOTICE:
• Always fasten seat belt when
operating unit with the ROPS in
the upright position.
• Do not fasten seat belt when
operating unit with the ROPS in
the down position.
• See “Roll-Over Protective
Structure” on page 86.
6. Operator presence
switch
Detects when operator is
seated.
Item Description Notes
To Next Page
Loading...
