420sx Operator’s Manual Plow - 65
Setup
CMW
Position Tractor
1. Fasten and adjust seat belt.
2. Start tractor. See page 50 for start-up procedures.
3. Drive to starting point. Move in line with planned path. See page 52 for operating procedures.
4. Engage parking brake.
5. Lower plow blade to starting point of path.
6. Turn ignition switch to STOP.
Attach Product
To Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
To Feed Product
1. Remove cable guide.
2. Feed cable through tube from top to bottom.
3. Replace cable guide and tighten fasteners.
4. Secure cable.
NOTICE: Keep everyone away from
material being installed.
To Next Page
Loading...
