Ditch Witch FX30 - Page 106

106 FX30 - MAINTENANCE
HYDRAULICS
106 FX30 - MAINTENANCE
HYDRAULICS
Hoses
Check hoses every 10 hours for wear or damage. Replace as
needed.
NOTICE: Use cylinder lockout
tools (provided with unit) if
hydraulic system must be serviced
with tank tilted up.
If 500 or 800:
• Raise vacuum tank.
• Remove cylinder lockout tool
and place over extended
cylinder rod.
• Lower vacuum tank until load
is supported by cylinder
lockout tool.
If 1200:
• Raise vacuum tank.
• Pull pin and move cylinder
lockout tool down until it clicks.
• Lower vacuum tank until load
is supported by cylinder
lockout tool.
Crushing weight could cause
death or serious injury. Use proper procedures
and equipment or stay away.
500 and 800
1200
Hoses
Check hoses every 10 hours for wear or damage. Replace as
needed.
NOTICE: Use cylinder lockout
tools (provided with unit) if
hydraulic system must be serviced
with tank tilted up.
If 500 or 800:
• Raise vacuum tank.
• Remove cylinder lockout tool
and place over extended
cylinder rod.
• Lower vacuum tank until load
is supported by cylinder
lockout tool.
If 1200:
• Raise vacuum tank.
• Pull pin and move cylinder
lockout tool down until it clicks.
• Lower vacuum tank until load
is supported by cylinder
lockout tool.
Crushing weight could cause
death or serious injury. Use proper procedures
and equipment or stay away.
500 and 800
1200