Ditch Witch FX30 - Emergency Procedures

FX30 - SAFETY 41
EMERGENCY PROCEDURES
FX30 - SAFETY 41
EMERGENCY PROCEDURES
EMERGENCY PROCEDURES
Before operating any equipment, review emergency procedures
and check that all safety precautions have been taken.
EMERGENCY SHUTDOWN - Turn ignition switch to stop position
or push remote engine stop button.
Electric Strike Description
When working near electric cables, remember the following:
• Electricity follows all paths to ground, not just path of least
resistance.
• Pipes, hoses, and cables will conduct electricity back to all
equipment.
• Low voltage current can injure or kill. Almost one-third of
work-related electrocutions result from contact with less than
440 volts.
If an Electric Line is Damaged
1. DO NOT TOUCH ANY EQUIPMENT.
2. Stay where you are unless you are wearing electric insulating
boots. If you leave, do not return to area or allow anyone into
area until given permission by electric company.
3. Contact utility company immediately.
EMERGENCY PROCEDURES
Before operating any equipment, review emergency procedures
and check that all safety precautions have been taken.
EMERGENCY SHUTDOWN - Turn ignition switch to stop position
or push remote engine stop button.
Electric Strike Description
When working near electric cables, remember the following:
• Electricity follows all paths to ground, not just path of least
resistance.
• Pipes, hoses, and cables will conduct electricity back to all
equipment.
• Low voltage current can injure or kill. Almost one-third of
work-related electrocutions result from contact with less than
440 volts.
If an Electric Line is Damaged
1. DO NOT TOUCH ANY EQUIPMENT.
2. Stay where you are unless you are wearing electric insulating
boots. If you leave, do not return to area or allow anyone into
area until given permission by electric company.
3. Contact utility company immediately.