Ditch Witch FX30 - Page 85

FX30 - LUBRICATION 85
BLOWER
FX30 - LUBRICATION 85
BLOWER
Bearings
Wipe two zerks (1) clean and lube
every 50 hours with HTG. Inject
grease into zerk until clean grease
comes out of relief fittings.
NOTICE: Do not inject grease too
quickly. Drive shaft seal damage
could occur.
Long-Term Storage
Lubricate blower before long-term
storage to help prevent rust and
lockup.
1. Remove plug from fitting at
filter (shown).
2. Start engine.
3. Spray light oil into port and run
unit for 1-2 minutes.
4. Turn off engine.
1
om2432a.eps
500 and 800
om0656h.eps
1200
Bearings
Wipe two zerks (1) clean and lube
every 50 hours with HTG. Inject
grease into zerk until clean grease
comes out of relief fittings.
NOTICE: Do not inject grease too
quickly. Drive shaft seal damage
could occur.
Long-Term Storage
Lubricate blower before long-term
storage to help prevent rust and
lockup.
1. Remove plug from fitting at
filter (shown).
2. Start engine.
3. Spray light oil into port and run
unit for 1-2 minutes.
4. Turn off engine.
1
om2432a.eps
500 and 800
om0656h.eps
1200