Drive - 76 JT1220 Mach 1 Operator’s Manual
Start Unit
CMW
Start Unit
1. Insert key.
2. Turn key clockwise. See page 21 for more information.
3. Run engine at low throttle for 5 minutes.
Steer Unit
To steer drilling unit while using tethered ground drive controller, follow instructions
for type of steering desired.
To steer while moving forward, push forward and then move to left or right.
Drilling unit will gradually turn to left or right.
To steer while moving backward, pull back and then move to left or right. Drilling
unit will gradually turn to left or right.
For tight steering in low speed, move control to center position and then to a corner. Tracks will counter-
rotate and turn drilling unit in a tight circle.
Shut Down Unit
1. Stop track movement.
2. Lower drill frame and stabilizers to the ground.
3. Run engine at low throttle for 3 minutes to cool.
4. Turn key to STOP.
5. Remove key.
IMPORTANT: If frame and stabilizers cannot be lowered, use cylinder locks or other suitable
material to block the tracks. Remove cylinder locks or chocks before driving unit.
c00ic145h.eps
To Next Page
Loading...
