Complete the Job - 104 RT80 Operator’s Manual
Restore Jobsite
CMW
Restore Jobsite
After product is installed, return spoils to the trench
with backfill blade.
Backfilling
1. Position unit at end of trench, several feet from
spoils. Aim tractor at outer edge of spoils.
2. Adjust backfill blade to fit land contour.
3. Move outer edge of spoils toward trench. Take
two or more passes at spoils rather than moving
all spoils at once.
4. Repeat on other side of trench, if necessary.
5. Engage float and make final pass over trench.
Rinse Equipment
Spray water onto equipment to remove dirt and mud.
Stow Tools
Make sure all tools and accessories are loaded and properly secured on trailer.
NOTICE: Do not spray water onto operator’s console. Electrical components could be damaged. Wipe
down instead.
To Next Page
Loading...
Need help?
General
