Service - 106 RT80 Operator’s Manual
Service Precautions
Service Precautions
Welding Precaution
Cleaning Precaution
Incorrect procedures could result in death, injury, or property damage.
Learn to use equipment correctly.
NOTICES:
• Unless otherwise instructed, all service should be performed with engine off.
• Refer to engine manufacturer’s manual for engine maintenance instructions.
• Before servicing equipment, lower unstowed attachments to ground.
NOTICE: Welding can damage electronics.
• Disconnect battery at battery disconnect switch, if equipped, or disconnect battery cables before
welding to prevent damage to battery. Do not turn off battery disconnect switch with engine
running or alternator and other electronic devices may be damaged.
• Connect welder ground clamp close to welding point and make sure no electronic components
are in the ground path.
• Always disconnect the ECU ground connection from the frame, harness connections to the ECU,
and other electronic components prior to welding on machine or attachments.
NOTICE: When cleaning equipment, do not spray electrical components with water.
To Next Page
Loading...
