Trench - 74 RT80 Operator’s Manual
Setup
CMW
Setup
1. Fasten and adjust seat belt.
2. Start tractor. See page 60 for start-up procedures.
3. Drive to starting point. Move in line with planned trench.
4. Switch transmission speed to low.
5. Switch hydraulic ground drive motor speed to low.
6. Lower backfill blade.
7. Swivel seat to desired position.
8. Lower boom to just above ground.
9. Engage optional Trench Depth Meter, if equipped. See page 99.
10. Check that attachment speed/direction control and ground drive hand control and foot pedal are in
neutral.
11. Check that boom is in line with planned trench.
EMERGENCY SHUTDOWN - Turn ignition switch to STOP.
Crushing weight could cause death or serious injury. Use proper
procedures and equipment or stay away.
NOTICE: Use attachments or counterweights to make front and rear loads balance when all
attachments are raised. Contact your Ditch Witch dealer about counterweighting for your equipment.
Jobsite hazards could cause death or serious injury. Use
correct equipment and work methods. Use and maintain proper safety
equipment.
NOTICE: Comply with all utility notification regulations before digging or drilling.
Incorrect procedures can result in death, injury, or property damage.
Learn to use equipment correctly.
To Next Page
Loading...
Need help?
General
