DITEC Entrematic HomeLink E2H User Manual

DITEC S.p.A.
Via Mons. Banfi, 3 - 21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
E2H
IP1967EN
rev. 2012-07-31
Installation manual for control panel for 2-motor 24V automations with built-in radio.
EN
F1
BATK1
UP
JR5
COM
DOWN

ENTERESC
24V
LN
POWER
TRF
AUX
1 5 9 13 L N
36 35 34
Power supply
JR1
33 32 31 15 14 0 1 5 20 0 1 6 0 1 8
BAT
ANT
Power unit
Memory
card
GOL4
24V= 24V=
Motor2 Motor1
Flashing light
Electric lock
Stop safety contact
Lamp
Step by step Step by step
Partial opening
Stop
-
+
-
+
Output 24 V= Output 24 V=
Reversal safety contact

DITEC Entrematic HomeLink E2H Specifications

General

Brand	DITEC
Model	Entrematic HomeLink E2H
Category	Control Panel
Language	English

Summary

GENERAL SAFETY PRECAUTIONS

EC DECLARATION OF CONFORMITY

TECHNICAL DATA

Applications

Illustrates how the control panel is used in different automation scenarios.

CONNECTION OF POWER SUPPLY

COMMANDS

SOFA1-SOFA2 or GOPAVRS self-controlled safety edge

Configuration and connection of self-controlled safety edges.

OUTPUT AND ACCESSORIES

SELECTION

SIGNALS

ADJUSTMENT

Switching on and off

Procedure for turning the display on and off.

Key combinations

Explains various command functions using key combinations.

AT (Automatic Configurations)

Predefined settings for residential and condominial use, and reset options.

BC (Basic Configurations)

Menu for basic configurations like stop verification, auto-closing, and commands.

BA (Basic Adjustments)

Adjustments for automation type, obstacle thrust, and limit switch modes.

RO (Radio Operations)

Storing, deleting, and managing radio transmitters.

SF (Special Functions)

Setting passwords, resetting configurations, and saving user settings.

CC (Cycles Counter)

Viewing manoeuvre counters and setting maintenance alarm intervals.

AP (Advanced Parameters)

Advanced parameters for disengagement, sequence, and acceleration.

DISPLAY VIEWING MODE

Automation status display

Displays the current operational status of the automation.

Commands and safety devices display

Displays commands and the status of safety devices.

Alarms and anomalies display

Displays system alarms and operational anomalies with remedies.

STARTING

RADIO RECEIVER OPERATION

EXAMPLE APPLICATION OF AUTOMATION WITH TWO SWINGING DOOR WINGS

EXAMPLE APPLICATIONS FOR AUTOMATION WITH ONE SWINGING DOOR WING