Using the NiTek Duo
NiTek Duo Dive Computer User Manual 17
To set the safety factor:
1. Press Mode until “dive” is displayed and flashing on the
screen.
2. Press Select until the safety factor field is flashing.
3. Press Set to select the desired safety factor.
4. When finished, press Select to advance to the next option
(profile sampling rate) or to exit, press and hold Mode for 1
to 2 seconds to return to time mode.
Setting the dive profile sampling rate
The NiTek Duo allows you to choose how frequently it samples
and stores depth data. The data it samples and stores is used in
profile mode or when the data is uploaded to a personal
computer. There are two sampling rates to choose from, 15-
second and 30-second.
The 15-second sampling rate enables the computer to sample and
store depth data every 15 seconds during a dive. The 15-second
sampling rate provides a more detailed dive profile, but because
it stores more information, fewer dives can be stored.
The 30-second sampling rate enables the computer to sample and
store depth data every 30 seconds during a dive. The 30-second
sampling rate is the computer’s “default” setting. The 30-second
rate provides a less detailed dive profile, but it is capable of
storing more information for more dives.
Note: When the computer’s memory storage is full, it overwrites
the oldest dive profile data stored with the new information.
To set the dive profile sampling rate:
1. Press Mode until “dive” is displayed and flashing on the
screen.
2. Press Select until the sampling rate “number” is flashing.
3. Press Set to toggle between 15- and 30-seconds.
4. When finished, press Select to advance to the next option
(fresh or salt water use) or to exit, press and hold Mode for 1
to 2 seconds to return to time mode.
To Next Page
Loading...
