Need help?Do you have a question about the dixell iCHILL IC208CX and is the answer not in the manual?
General| Brand | dixell |
|---|---|
| Model | iCHILL IC208CX |
| Category | Temperature Controller |
| Language | English |
Essential safety guidelines for using the instrument, covering voltage, moisture, maintenance, and opening the unit.
Overview of the primary functions and capabilities of the iCHILL IC200CX controller for chiller applications.
Details on how to configure the main and secondary displays for various measurements and parameters.
Steps to change the setpoint value for chiller or heat pump modes.
Configuration options for analog inputs PB1, PB2, PB5, and PB6, including probe types.
Configuration options for analog inputs PB3 and PB4, including probe and signal types.
Configuration settings for digital inputs ID1 through ID18.
Configuration options for digital outputs (relays) RL1 through RL8.
Configuration of analog outputs OUT1 and OUT2 for various control signals.
Configuration of analog outputs OUT3 and OUT4 for 0-10V signals or phase cut control.
Procedure for downloading instrument parameters using a programmed Hot Key.
Procedure for uploading instrument parameters to a Hot Key.
Steps to access the Pr1 (User), Pr2 (Maintenance), and Pr3 (OEM) programming levels.
Procedure for navigating and modifying parameter values using the keyboard.
Instructions on how to change the password for each programming level.
Detailed steps to enter and navigate the Pr1 (User) programming level.
Detailed steps to enter and navigate the Pr2 (Maintenance) programming level.
Detailed steps to enter and navigate the Pr3 (OEM) programming level.
Configuring the polarity for digital inputs and outputs, and proportional outputs.
Step-by-step guide to modify the polarity of digital inputs and outputs.
List of functions accessible via the 'M' key, including alarms and resets.
Procedure to view and reset active alarms from the alarm list.
How to reset compressor overload alarms via the function menu.
How to select and enable the unit's operation mode (Chiller or Heat Pump).
Methods for starting, stopping, and managing the unit's standby state.
Detailed explanation of parameters related to compressor thermoregulation.
Explanation of proportional and neutral zone types for compressor thermoregulation.
Configuration for compressor rotation sequence based on time or starts-up.
Details on direct start-up and part-winding start-up for compressors.
Configuration options for managing compressor capacity steps.
Management and troubleshooting of pump down alarms during compressor start-up and switch-off.
Operational modes for the evaporator water pump and supply fan.
Operational modes for the condenser water pump.
Configuration for modulating control of evaporator and condenser pumps.
Initiating a defrost cycle manually or under specific conditions.
Defrost cycle managed by combined temperature inputs.
Procedure for performing a manual defrost cycle.
Detailed steps and phases of the automatic defrost cycle.
List and description of various alarm codes and their meanings.
To Next Page
