', ;,( &+233(5
OPERATING YOUR
TO CHANGE SPEED OR DIRECTION
To change direction of machine, slowly move levers
to neutral and move levers in direction you want to go.
The further levers are moved away from neutral
position, the faster machine will travel. To turn
machine left or right, slow speed of wheel in direction
you want to turn.
TO STOP
To stop machine, return both levers evenly to
neutral position.
CORRECT MACHINE USAGE
CAUTION
Read manuals provided with attachments
before operating. These manuals give a more
detailed description of operation and point out
other areas of caution. Familiarize yourself
thoroughly with equipment before attempting to
use it.
OPERATION OF THE MACHINE WITH
MOWER
IMPORTANT
Keep all shields and mower discharge chute in
place. Never attempt to clear discharge areas or
mower blades without disengaging mower and
removing ignition key.
For best operation on average lawns, operate
engine at full throttle; control ground speed with
transmission. Average lawns ate usually cut at a
height between 2 and 3 in. (5-7.6cm). Tall grass and
weeds should be cut with the mower in its highest
position, making a second pass cutting to height
desired. Always keep mower blades sharp.
SECTION 5
MOWING MACHINE
MOWING SPEED
Mower is designed to operate most efficiently at
maximum blade speeds. Speed of machine should
allow mower blades to maintain this maximum speed
while mowing across turf. Slow machine for cutting tall
grass, grass that is heavy with moisture, or when
moving uphill. If ground speed is too fast, or blade
speed is too slow, mowing will be uneven because
mower blades will not be able to lift grass into cutting
position as mower passes over ground.
MOWING HEIGHT
Best cutting height for your lawn has probably been
established from previous experience. First time you
mow, set mower to cut a little higher than you have in
past. This will help you determine the best approach
to uneven areas, to be sure wider cut does not result
in scalping high spots, in general, recommended
cutting height is 2 to 3 in. (5-7.6cm).
Very tall grass can be cut without difficulty by using
a little care. Set mower in its highest cutting position
and enter area slowly. If necessary, take a cut one
half width of mower, overlapping previously cut area
on each pass. Then, with mower set to desired height,
make a finish cut over entire area.
To Next Page
Loading...
