Page 5 of 72
GROUND THE VENDER
The vender is equipped with a three wire power supply cord and MUST be plugged into a properly
grounded outlet.
DO NOT REMOVE THE GROUND PIN OR IN ANY WAY BYPASS THE GROUNDING OF
THE VENDER. If the outlet will not accept the power cord plug, contact an electrician to install a
proper AC outlet.
WARNING: Failure to comply with these instructions may subject the user to the risk of
injury or electrical shock which can be serious or fatal.
COIN CHANGERS
The Series 90 Vender must have a coin changer installed. Most styles can have a bill acceptor installed. If
the coin changer and other accessories are not factory installed, refer to the instructions received from the
manufacturer of the coin changer and other accessories for proper set-up and installation.
SINGLE PRICE VENDERS
The following single price coin changers will work properly with the Series 90 Single Price Vender:
MARS Electronics Int. Coin Acceptors, Inc. Crane Int'l. Currency CONLUX-USA
TRC 6200 MC 5802 3340-S S75-9400B-977 525E US-111A-1
TRC 6200C MC 5800 9340-S S75-9800B-907 525C US-111A-1D
TRC 6800 MC 5800 DH 9360-S 525EC USA-121 A-OC
TRC 6800 H 9370-S 500
TRC 6800 C S300E9240 510
TRC 6800 HC
SIID VENDERS
The following coin changers will work with the Series 90 SIID vender:
Micro-Mech/Controller 110V (12 pin) Changers (domestic)
Mars TRC 6000
Coinco 9300L
Maka USPX001
Micro-Mech Controller 24V (15 pin) Changers (domestic)
CAUTION: DO NOT USE 24V(12 PIN) CHANGERS. USE OF 24V (12 PIN) CHANGERS WILL
CAUSE DAMAGE TO ELECTRONICS PACKAGE AND CHANGER.
Multi-Drop Coin Mech (domestic)
Coinco 9302GX
Mars TRC 6510
L+ Coin Mech (International)
To Next Page
Loading...
