16
SPECIFICATIONS
ZEETER 42”
CHASSIS: 11 gauge welded channel frame
BODY: All body parts made of rotational molded polyethylene. Front
body contains access panel for battery service. Seat tilts
forward to allow transmission service.
MOWER DECK: 13 GA stamped steel construction. Three blades
combine for a 42” cut width. Cut height approximately
1-1/2” - 4” via 7-position lift handle.
BLADE DRIVE: Electric clutch
TRANSMISSION: Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
ENGINE: 13 HP Briggs & Stratton Powerbuilt, 4-cycle, single
cylinder, air-cooled, gasoline, vertical shaft, aluminum
head and block.
STARTING SYSTEM: Electric by key switch operation with safety interlocks
on parking brake and blade drive.
TIRES: Front 9 x 3.50-4 Turf Saver
Rear 16 x 6.50-8 Turf Saver
RECOMMENDED Front 16-21 PSI
TIRE PRESSURE: Rear 8-14 PSI
CAPACITIES: Fuel 3 quart
Engine 1.25 quarts oil
DIMENSIONS: Width 35” outside rear wheel measurement
Width 55” overall width of deck with deflector
Height 31” to top edge of seat
Length 65.5” hitch tab to front
Weight 427 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
To Next Page
Loading...
