© 2018 DJI All Rights Reserved.
11
Installation
Threadlocker of medium strength is required for installation. Apply threadlocker when
mounting the landing gear, power port module, spray tank, sprinklers, and radar module.
Ensure the threadlocker is totally dry and solid before ight.
DO NOT bend the hoses in an arc tighter than their minimum bend radius during
installation. This is to avoid creasing, which may compromise the spraying effect.
Ensure that all installation and connection procedures are completed before powering on
the aircraft.
The installation steps are the same for both the MG-1P and MG-1P RTK. In the gures below the
MG-1P is shown.
Mounting the Landing Gear
1. Identify the landing gear leg containing the compass cable.
2. Take out the compass cable from the tube of the landing gear leg and connect it to the compass
port on the aircraft’s right side, then mount the right landing gear leg to the mounting position.
Be careful not to damage the cable.
3. Secure the right landing gear leg in place using four M3×10 screws.
4. Mount the left landing gear leg and secure it in place using three M3×10 screws.
Aircraft Rear
Compass Port
Compass Cable
Insert into the upper
screw hole
To Next Page
Loading...
