dji AGRAS MG-1P Series - Remote Controller LEDs and Linking

AGRAS MG-1P SERIES User Manual
© 2018 DJI All Rights Reserved.
23
RTH Status LED
Status LED
The Status LED indicates the connection status between the remote controller and the aircraft. The
RTH Status LED indicates the Return to Home status of the aircraft. See the table below for details
on these indicators:
Status LED Sound Remote Controller Status
— Solid Red chime
The remote controller is not connected to
the aircraft.
— Solid Green chime
The remote controller is connected to the
aircraft.
Blinks Red Repeating slow beep Remote controller error.
RTH Status LED Sound Aircraft Status
— Solid White chime Return to Home procedure is initiated.
Blinking white Repeating single beep
Sending Return to Home command to the
aircraft.
Blinking white Repeating double beep The aircraft is returning to the Home Point.
Try to keep the aircraft inside the optimal transmission zone. If the signal is weak, adjust the
antennas or y the aircraft closer.
Remote Controller LEDs
Optimal Transmission Zone
Weak
Strong
Optimal Transmission Zone