dji AGRAS MG-1P Series - Return to Home (RTH)

AGRAS MG-1P SERIES User Manual
© 2018 DJI All Rights Reserved.
41
An indication appears in the DJI MG app and the aircraft hovers in place when the spray tank
is empty. In Route, A-B Route, and Manual Plus operation modes the aircraft can also be set to
ascend or Return to Home instead of hovering.
Usage
1. When an empty tank warning appears in the app, the sprinklers will automatically turn off.
2. Make sure that the aircraft is in Manual operation mode, land, and then stop the motors. Next,
rell the spray tank and tightly secure the cover.
3. Take off in Manual operation mode and y the aircraft to where the operation was interrupted.
Enter the desired mode to continue the operation.
Return to Home (RTH)
5. Initiate RTH
Blinks yellow
1. Record Home Point (HP)
Blinks green or purple
3. Remote Controller Signal Lost
Blinks yellow
2. Conrm Home Point
Blinks green six times
6. Land After Hovering 5 sec
Blinks yellow
4. Signal Lost > 3 sec
Blinks yellow
15m
Height over HP>15m
Elevate to 15m
Height over HP<=15m
Updating the Home Point
You can update the Home Point in the DJI MG app during ight. There are two options for setting
the Home Point:
1. Set the aircraft’s current coordinates as the Home Point.
2. Set the remote controller’s current coordinates as the Home Point.
Ensure the space above the remote controller’s GNSS module (located beneath the DJI
logo) is not obstructed and that there are no tall buildings around when updating the Home
Point.
Follow the instructions below to update the Home Point:
1. Go to DJI MG > Operation View.
2. Tap > , select in Home Point settings to set the aircraft’s current coordinates as the
Home Point.