dji FPV REMOTE CONTROLLER - Mounting the Battery

EN
4
Strong Weak
2. Mounting the Battery
3. Checking the Battery Level and Power On/O
Press once to check the battery level.
Press once, and press again and hold
for two seconds to turn on or off.
Low High
To remove the Intelligent Battery, open the cover, press and hold the battery release
button, and push the battery downward.
4. Preparing the Antennas
Unfold and adjust the antennas of the remote controller. The signal strength varies
depending on the position of the antennas.
Try to keep the aircraft inside the optimal
transmission range. If the signal is weak,
adjust the antennas or fly the aircraft closer.
Unfolding the Antennas
Optimal Transmission Range
2
3
1
2
3
Battery
Release
Button
Slide the battery cover lock on the back
of the remote controller down to open the
cover.
Insert the Intelligent Battery into the
compartment. Press the battery into place
and push upward until there is a click.
Close the cover.