2. Connect HDMI /AV port to the FPV camera.
3. Connect DBUS port on air system to DBUS port (X2 port) on flight control system with DBUS cable.
4. Refer to gimbal and flight control system manuals to complete connection.
Ground system connection：
5. Connect remote control to the ground station via training port.
6. Connect mobile devices or HDMI monitor to the master and slave ground station.
7. Launch DJI LIGHTBRIDGE App and configure the Master –Slave mode in “App Settings”. It is
recommended to use “Master” ground system to receive FPV video signal and “Slave” ground
system to receive gimbal video signal.
To Next Page
Loading...
