dji MATRICE 600 - Mounting the Retractable Modules

8
©
2016 DJI. All Rights Reserved.
Before You Begin
The following documents have been produced to help you safely operate and make full use of your
Matrice 600:
Matrice 600 In the Box
Matrice 600 Disclaimer and Safety Guidelines
Matrice 600 Quick Start Guide
Matrice 600 Intelligent Flight Battery Safety Guidelines
Matrice 600 User Manual
Check to see that you have all of the components listed in the Matrice 600 In the Box document. Before
assembly, read the
Matrice 600 Disclaimer and Safety Guidelines . Get prepared using the Matrice 600
Quick Start Guide
. Complete the assembly with the help of the Matrice 600 User Manual and the video
tutorial on the DJI website (http://www.dji.com). For more information, please refer to the
Matrice 600
User Manual
available on the DJI website. Make sure you fully understand the functionality of each
individual part, the ight condition requirements, the key contingency warning functions/systems, and all
government regulations before each ight. If you have any questions or problems during the assembly,
maintenance or use of this product, please contact DJI or a DJI authorized dealer.
Individual Parts
Regarding Genuine and Functional Parts
To avoid component malfunction, serious injury, and property damage, observe the following rules:
1.
Use only genuine DJI parts or parts certified by DJI. Unauthorized parts or parts from non-DJI
certied manufacturers may cause system malfunctions and compromise safety.
2.
Ensure there are no foreign objects (such as water, oil, soil, sand, etc.) inside of the aircraft or its
components.
3.
Ensure the aircraft and its components-including but not limited to the remote controller, ight
controller, Lightbridge
TM
2 Air System, landing gear, GPS, compass, propulsion system, and
batteries-are all in good working order, damage-free, and functioning well. Refer to the remaining
sections in this document for more details on how to ensure the functionality of these components.
4.
DO NOT remove parts that come with the aircraft-including but not limited to the ight controller,
power management unit, and Lightbridge 2 Air System-for other uses. DO NOT replace any of them
with other parts.
Remote Controller
1. Ensure the remote controller is fully charged before each ight.
2. If the remote controller is powered on and has NOT been used for 5 minutes, it will sound an alert. After 10
minutes it will automatically power off. Move the sticks or perform some other action to cancel the alert.
3. Adjust the clamp of the mobile device holder to allow a rm grip on your mobile device.
4. Ensure the mobile device holder is rmly in place and does not slip.
5. Ensure the antennas of the remote controller are unfolded and adjusted to the proper position to achieve
optimal transmission quality.
6. Repair or replace the remote controller if damaged. A damaged remote controller antenna will greatly
decrease performance.