dji MAVIC AIR - Page 26

26
©
2018 DJI All Rights Reserved.
Mavic Air
User Manual
3. Tap once on the target and wait for the “GO” button to appear. Tap the “GO” button to conrm the
selection and the aircraft will y to the target automatically. A prompt will appear if the target cannot
be reached. If this is the case, select another target and try again. The target can be changed mid-
ight by tapping the screen.
Point of Interest
Select a subject, and set the circle radius, ight altitude, and ight speed, and the aircraft will y around
the subject according to these settings.
12
61%
2.4G
12
09:29
ISO
SHUTTER
EV
WB
1600 0.31/8000
CAPACITY
1080P/2420GB
GO
TapFly
In flight (GPS)
Forward
Reverse CoordinateFree
139m
7m/s 1.1m/s 627m
612m
N
POINT OF INTEREST
Exit
3M/S
12M
34M
Flight Altitude Circle Radius
Stop
Exiting TapFly
Press the Flight Pause button on the remote controller or pull a control stick in the direction opposite to
the direction of ight and the aircraft will brake and hover in place. Tap the screen to resume TapFly. Tap
or toggle the Flight Mode switch to S-mode to exit TapFly.
DO NOT use TapFly in areas with people, animals, small or ne objects (e.g. tree branches or
power lines), or transparent objects (e.g. glass or water). TapFly Mode may not work properly
when the aircraft is ying over water or snow covered areas.
There may be deviations between expected and actual ight paths selected in TapFly.
The selectable range for the target direction is limited. You cannot make a selection close to
the upper or lower edges of the screen.