©2014 DJI Innovations. All Rights Reserved.34 |
For ‘Ready to Fly (non-GPS)’ the aircraft will keep the aircraft level without horizontal
positioning when all sticks are released.
5.6 Link between the Remote Controller and Receiver
A5.8G receiver is built-in PHANTOM 2 VISION+, its link button and indicator loc a te do n the bottom of the aircraft as
illustrated in the following diagram.
The link between the remote controller andreceiver isalready established before delivery. Only re-establish the link
when you try to replace the old remote controller or receiver with a new one.
L in k B u tto n &
L in k In d ic a t o r
Power off the remote controller, power on the aircraft.You will see the link indicator blinking red.
Press the linkbutton with a thin object and hold until the link indicator blinks yellow.Release the
linkbutton.
Power on the remote controller and the link indicator shouldswitch off. This indicates that the link has
been successfully established.
Switch on the remote controller or perform a link procedure.
Switch on the remote controller.
5.7 Compliance Version Configuration
The compliance version can be reconfigured by twisting the potentiometer knob (See the following diagram) on
the back of the remote controller using a flathead screwdriver. For CE compliance, set the remote controller to CE
compliance by carefullyturning the potentiometer knob to the full counter clock-wise position.For FCC compliance,
set the remote controllerto FCC compliance by carefully turning the potentiometer knob to the full clock-wise
To Next Page
Loading...
Need help?
General
