Appendix
Phantom 4 Pro / Pro+ Use Manua
66
©
2017 DJI All Rights Reserved
After-Sales Information
Visit the following pages to learn more about After-sales policy and warranty information:
1. After-sales Policy: http://www.dji.com/service
2. Refund Policy: http://www.dji.com/service/refund-return
3. Paid Repair Service: http://www.dji.com/service/repair-service
4. Warranty Service: http://www.dji.com/service/warranty-service
Compliance Information
FCC Comp ance Not ce
This device complies with Part 15 of the FCC Rules. Operation is subject to the following tw conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible or compliance could void
the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits fo a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide rea onable protection against harmful
interference in a residential installation. This equipment gen rates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o f and on, the user is encouraged to try to correct the
interference by one or more of the following me sures:
— Reorient or relocate the receiving antenna
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an expe ienced radio/TV technician for help.
RF Exposure Informa on
This equipment compli s with FCC radiation exposure limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to
the antenna shall not be less than 20cm during normal operation.
IC RSS Warn ng
This d vice complies with Industry Canada licence-exempt RSS standard (s). Operation is subject to the
ol wing two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
