4. Test the balance with Auto Tune
Start Auto Tune:
After you balance the gimbal, unlock the
motors of the three axes (tilt, roll and pan)
and turn it on.
Use Auto Tune on the gimbal touch screen
to test your balancing. The gimbal will
shake slightly and make motor noises
when this is happening.
If you are using Supersmooth mode, make
sure to turn that on and make sure the
gimbal has been balanced with the lens
support attached.
Rebalance if the icon is red, and consider
rebalancing if it is orange.
Auto Tune
Green icon
means
balanced.
Turn on Super Smooth
To Next Page
Loading...
