to the left, move the camera to the right. If the camera rotates to the right, move the camera to the left.
b. Loosen the knob on the camera mounting plate (1) , and adjust position of the plate (2) until the camera is steady.
c. Tighten the knob. If the camera moves forward, move the camera back until the slider is next to the mounting plate.
4. Balancing the pan axis
a. Unlock the pan axis. Hold the grip, tilt Ronin-SC sideward, and check the movement of the pan axis. If the camera
lens rotates downward, push the pan axis backward. If the camera lens rotates upward, push the pan axis forward.
b. Loosen the knob on the pan motor (1) . Adjust the camera balance (2) until the camera is steady when rotating the
pan while lifting the grip.
c. Tighten the knob.
Operation
Auto Tune
After installation, activation, and balancing, Ronin-SC must be auto-tuned before it can be used. Make sure to place
Ronin-SC on a flat surface before conducting an auto tune. There are two ways to auto-tune Ronin-SC.
A. Press and hold the M button and trigger on Ronin-SC simultaneously for four seconds to start Auto Tune.
B. Launch the Ronin app, go to the Motor Parameters page,
To Next Page
Loading...
