1. The three axes of the gimbal are locked by default. Unlock the three axes, adjust the gimbal to the position as
shown, and lock the three axes again.
2. If required, attach the riser plate* to the bottom of the camera using a flathead screwdriver.
* Riser plate is required in the following scenarios:
• When using a small and lightweight camera such as a Sony A6300 camera.
• When using a lens with a large diameter such as a Sony A7M3 camera with a 16-35 mm f/2.8 GM lens.
• When used with a focus motor.
Refer to the Ronin-SC product page on the official DJI website (http:// www.dji.com/ronin-sc) for the most
updated Camera Compatibility List.
3. Attach the dovetail plate (1) and lens support (2). Move the slider to the front of the plate. The camera lens and
the arrow on the dovetail plate must face the same direction. Mount the camera according to the indicators on
the dovetail plate. Use the lens support for optimal performance.
To Next Page
Loading...
