10
6. Auto-discharging: The battery automatically discharges to below 65% of total charge when it is idle for more
than 10 days to prevent swelling. It takes around 2 days to discharge the battery to 65%. It is normal to feel
moderate heat emitting from the battery during the discharge process. Discharge thresholds can be set in the
DJI GO app.
7. Balanced Charging: Automatically balances the voltage of each battery cell when charging.
8. Short Circuit Protection: Automatically cuts the power supply when a short circuit is detected.
9. Battery Cell Damage Protection: The DJI GO app shows a warning message when a damaged battery cell is
detected.
10. Battery Error History: Browse the battery error history from the DJI GO app.
Using the Battery
Powering On/Off
Powering On: Press the Power Button once, then press and hold it for 2 seconds to power on. The Power LED will
turn red and the Battery Level Indicators will display the current battery level.
Powering Off: Press the Power Button once, then press and hold it for 2 seconds to power off.
Low Temperature Notice
1. Using the Intelligent Flight Battery at core temperatures below -10°C (14°F) is not advised. Between -10°C
(14°F) and 5°C (41°F), the Intelligent Flight Battery should attain a voltage of 4.2 V, but it is recommended
applying the insulation sticker to the battery to avoid a rapid drop in temperature.
2. In cold environments (i.e. air temperature below 5°C (41°F)), the performance of the Intelligent Flight
Battery is reduced. Ensure the Intelligent Flight Battery is fully charged and attains a voltage of 4.35 V before
takeoff.
3. In very cold environments (e.g. air temperature of -20°C (-4°F), battery core temperature of 5°C (41°F)), the
Intelligent Flight Battery’s core temperature will drop rapidly even after pre-heating, and its performance is
significantly reduced. It is not recommended to fly under such conditions.
4. If the DJI GO app displays the Low Battery Level warning, stop flying and land the aircraft immediately. You
will still be able to control the aircraft’s movement when this warning is triggered.
5. To ensure the optimal performance, maintain the Intelligent Flight Battery’s core temperature above 20°C
(68°F) in use.
Ensure the temperature of the Intelligent Flight Battery exceeds 5°C (41°F) before takeoff.
To warm up the battery, power on the Intelligent Flight Battery inside the battery compartment for
approximately 1-2 minutes before takeoff. Begin flying by hovering the aircraft at a low altitude (for
approximately 1 minutes) to ensure an appropriate battery temperature is reached.
To Next Page
Loading...
Need help?
General
