dji Zenmuse H3-3D - Firmware & Software Upgrade; Firmware Upgrade

14
©
2014 DJI. All Rights Reserved.
ZENMUSE H3-3D User Manual
Firmware & Software Upgrade
Firmware Upgrade
Follow the procedures below to upgrade the H3-3D’s rmware. Failure to follow these instructions
carefully may damage the gimbal.
1. Ensure your computer has access to the internet.
2. Close all other applications (including anti-virus programs or rewalls) before upgrading the
rmware.
3. Make sure the power supply is securely connected. DO NOT unplug the power supply before
the upgrade is complete.
4. Connect the GCU to your PC through a Micro-USB cable. DO NOT disconnect the cable until
the rmware upgrade is complete.
5. Launch the PC Assistant and wait until the connection is established.
6. Select “Upgrade”
Main Control, IMU and CMU.
7. The DJI server will check the current rmware version.
8. If a newer rmware is detected, the PC Assistant will download and upgrade the rmware
automatically.
9. Wait until the upgrade completes.
10. Click “OK” and power cycle (turn off, then turn on again) the system to finish the upgrade
process.
CMU stands for “Camera Multi Unit”, which is the management module for the camera.
To eliminate interference from the main controller, DJI recommends you disconnect the
CAN-Bus cable between the GCU and main controller before you upgrade the rmware.
Double check your set parameters once you have nished upgrading the rmware.
Repeat the above steps if the DJI server is experiencing heavy traffic or the firmware
upgrade fails.
Software Upgrade
Click Info Software Info. If the latest version is newer than your current version, please upgrade
your software.
Obtain your gimbal’s serial number (SN) by clicking the “Info”
“SN”. The serial number is a
32 digit authorization code that is used to activate the gimbal. This number is set at the time of
manufacture, before shipment. You may be prompted to ll in a new SN if you purchase a new
feature. If you ll an invalid SN more than 30 times, the gimbal will be locked and you will have to
contact our customer support to unlock the gimbal.