dji ZENMUSE H4-3D - Installation Overview

6
©
2015 DJI. All Rights Reserved.
ZENMUSE H4-3D User Manual
Installation
Gimbal Description
Ensure the gimbal servos are unobstructed, otherwise they may be damaged during operation.
If the gimbal becomes obstructed during operation, power off and clear all obstructions
immediately.
Always mount the camera before powering on the gimbal.
[
1
]
[
2
]
[
3
]
[
4
]
[
5
]
[
6
]
[
7
]
[
8
]
[1] Yaw servo driver module
[2] Upper plate of the damping unit
[3] Vibration absorbers
[4] Bottom plate of the damping unit
[5] Tilt servo driver module
[6] Roll servo driver module
[7] Camera mount
[8] 8
-
pin connector port (to GCU/Phantom 2)
F450 & Phantom 1 Adapter
For installing the H4-3D gimbal onto a F450 or Phantom 1.
F550 Adapter
For installing the H4-3D gimbal onto a F550. Must be used
with the above F450 adapter.
Installation