dji ZENMUSE H4-3D - Installing on Phantom 2; Phantom 2 (New Version) Installation

©
2015 DJI. All Rights Reserved.
7
ZENMUSE H4-3D User Manual
Installing H4-3D onto an Aircraft
Installing H4-3D onto a Phantom 2 (new version)
There are two versions of the Phantom 2. The latest Phantom 2 can hold the H4-3D gimbal
directly, while the older version of the Phantom 2 requires an adapter to hold the H4-3D. The
difference between the two versions can be seen on the bottom of Phantom.
Phantom 2 (new version) Phantom 2 (oid version)
Follow the instructions below to install the H4-3D gimbal onto a Phantom 2 (new version).
1. Insert the securing pins into the holes on the upper plate of the damping unit as shown
below. Then, attach the upper plate of damping unit to the Phantom 2 with four M3x5 screws.
Installation