dji ZENMUSE H4-3D - Page 8

8
©
2015 DJI. All Rights Reserved.
ZENMUSE H4-3D User Manual
3. Cover the securing pins with washers to lock the damping unit in place. Only push the
washers past the rst nut.
4. Plug the 8-pin cable from the Phantom 2 into the Phantom 2 port on the anti-interference
enhancement board. Then use the supplied 8-pin cable to connect the H4-3D port on the anti-
interference enhancement board to the 8-pin port on the gimbal.
2. Attach the bottom plate of the damping unit to the upper plate. To do this, insert the securing
pins on the tip of the vibration absorbers into the mounting holes on the bottom plate.
Installation