8 | OPC524 man. v.210518
ENGLISH
STEP 3: INSTALLING THE FEED CHUTE
ASSEMBLY
STEP BY STEP INSTRUCTIONS
1. Install the feed chute on the two hinges. To seat the hinge pins for the first time, a rubber mallet
may be used to tap the pins into the hinges. These are tight fitting to reduce vibration noise.
2. Close the chute and latch it.
3. Plug the safety shut o wire connectors together.
4. You can now use the chute by the handles to tip the unit back so you can perform the next step
and install the hitch.
To Next Page
Loading...
