DKS 1503 - Programming Five-Digit Entry Codes; Erasing Five-Digit Entry Codes; Programming Four-Digit Hold Codes; Erasing Four-Digit Hold Codes

Page 16 1503-065-E-3-14
2.5 Programming Five-digit Entry Codes
1. Press *9 and enter the four-digit master code (short beep).
2. Press 1* (beep) to enter the first five-digit entry code.
3. Enter the five-digit code _ _ _ _ _ then press * (beep).
(If a second code is not desired, skip steps 4 and 5).
4. Press 2* (beep) to enter the second five-digit entry code.
5. Enter the five-digit code _ _ _ _ _ then press * (beep).
6. Press 0# together to end the programming step (long beep).
2.6 Erasing Five-digit Entry Codes
1. Press *9 and enter the four-digit master code (short beep).
2. Press 1* (beep) to erase the first five-digit entry code.
3. Enter # # # # # then press * (beep).
(If a second code is not going to be erased, skip steps 4 and 5).
4. Press 2* (beep) to erase the second five-digit entry code.
5. Enter # # # # # then press * (beep).
6. Press 0# together to end the programming step (long beep).
2.7 Programming Four-digit Hold Codes
1. Press *7 and enter the four-digit master code (short beep).
2. Press 1* (beep) to enter the first four-digit hold code.
3. Enter the four-digit code _ _ _ _ then press * (beep).
(If a second code is not desired, skip steps 4 and 5).
4. Press 2* (beep) to enter the second four-digit hold code.
5. Enter the four-digit code _ _ _ _ then press * (beep).
6. Press 0# together to end the programming step (long beep).
2.8 Erasing Four-digit Hold Codes
1. Press *7 and enter the four-digit master code (short beep).
2. Press 1* (beep) to erase the first four-digit hold code.
3. Enter # # # # then press * (beep).
(If a second code is not going to be erased, skip steps 4 and 5).
4. Press 2* (beep) to erase the second four-digit hold code.
5. Enter # # # # then press * (beep).
6. Press 0# together to end the programming step (long beep).