弥 勒 浩 翔 科 技 有 限 公 司
Mile Hao Xiang Technology Co., Ltd
• It is strictly forbidden to disassemble the control system;
• Please charge the controller once every 1 to 2 months when the
Jetboard be stored.
6、Engine start sequence and notice
1 、 Insert the key into the handle to the stage 1, close the
carburetor choke plate with full throttle.
2、 Push start key to the stage 2, starter will be activated and
start the engine for 5 seconds and then stop; The engine will be
started for short time and off, as much fuel has been pumped
into combustion chamber.
3、Pull out the key, then open the carburetor choke plate, release the
throttle trigger to default position, then insert the key and restart the
engine again, the engine will running at idle speed. Slightly
accelerate the engine for 3-5 seconds and remove the key, the
Jetboard shall ready for use.
4、 If the starting is unsuccessful, repeat the steps above.
5、 If the engine can be not started after multi-attempts, there could
be too much fuel in combustible chamber. You need to remove the
excess fuel, please refer (How to remove water or excessive fuel in
the engine ).
Notice: Before starting, insert the key to stage 1 first, and then
press it to stage 2 when ready to surf (refer 9.5 for details). The
maximum starting timing shall not more than 10 seconds/time
on the shore. The interval time between each starts shall no less
than 30 seconds. (the engine will be overheated and damaged
To Next Page
Loading...