弥 勒 浩 翔 科 技 有 限 公 司
Mile Hao Xiang Technology Co., Ltd
Caution:
The engine mounting screws need to be applied with thread glue
(Loctite 242). The screws needs to be tightened diagonally and
evenly. The sealing surface of the engine body uses gasket-free
design. The surface needs to be cleaned properly and apply
anaerobic surface sealant (Loctite 518) evenly. When mounting
the one-way bearing, beware of the running direction (arrow
side goes up), use torque spanner to tight the screw (troque
28N*m).
4、Use notice of Thruster
4.1 Check and ensure that there are no obstructions, debris at the
impeller entrance or drive shaft, remove it if there is any.
4.2 If there is noticeable power decreasing, strong vibration, or
friction between the impeller and injection barrel, STOP the engine
To Next Page
Loading...