弥 勒 浩 翔 科 技 有 限 公 司
Mile Hao Xiang Technology Co., Ltd
2.5 Insert the key to start, the starter motor will drive the engine but
ignition will not ignite. Repeat the step 2-5 times to drain the water
(fuel) completely.
2.6 Close the drain valve, install the spark plug and put spark plug
cap back.
2.7 The engine shall be started successfully. If not, more water/fuel
could still remaining in the engine, please repeat the above steps.
3、Remove the engine
1）Loosen the the coupler lock screw.
2 ） Loosen the coupler mounting screw and pull backwards to
separate the coupler.
3）Remove the four engine mounting screws.
4）Remove the water pipe, oil pipe and cables.
To Next Page
Loading...